CMD-7 Disc pad VX840C
Organic disc pads, for Clarks CMD7 models. Remove caliper prior to fitting, 5mm Allen key needed. All Service work should be carried out by a fully qualified cycle mechanic
-
-
CMD-7 Cable adjuster 7-CA
Knurled adjuster and locking ring. Fits directly into caliper allowing cable tensioning without the need for a tool
-
CMD-7 Bracket Bolt M16 with metal washer 7-M16B
M16 allen key bolt. Slide the caliper bracket in behind the frame locating hole and use the bolt (plus washer) to tighten fully
-
CMD-7 Caliper Adjustment screw with spring 7-CAS
Adjustment bolt used in conjunction with the caliper bracket. This allen key headed bolt allows the caliper to be adjusted once fitted to the frame
-
CMD-7 Arm Spring 7-ASPR
Sprung return spring for use with CMD-7. Will require some disassembly of caliper unit.
-
-
CMD-7 Cable gripper and bolt 7-Grip
Cable pinch bolt and gripper plate. Screws directly into the rotation arm for tightening inner wire securely.
-
CMD-7 Back plate adjuster 7-BPA
Rear disc pad base plate for CMD-7. Once fitted can be adjusted to allow for disc pad wear.
-
CMD-7 Rear Bracket for 160mm 7-RB-160
CMD-7 bracket, available for 160mm rear fitting. White as standard, International Standard fitting
-
CMD-7 Front bracket for 160mm 7-FB-160
CMD-7 bracket, available for 160mmFront fitting. White as standard, International Standard fitting
-
CMD-7 Rear Bracket for 180mm 7-RB-180
CMD-7 bracket, available for 180mm Rear fitting. White as standard, International Standard fitting
-
CMD-7 Front Bracket for 180mm 7-FB-180
CMD-7 bracket, available for 180mm front fitting. White as standard, International Standard fitting